Content：
r.tecc Norplex VSP 2
Lithiumcomplex-Calcium EP Grease – NLGI-Grade 2
|
Description |
r.tecc Norplex VSP 2 / Rhenus Norplex VSP 2 is a natural colored Lithium complex-Calcium Grease with EP additives, based on high quality mineral oil. |
|
Application
and
Properties |
r.tecc Norplex VSP 2 / Rhenus Norplex VSP 2 suits for lubrication of roller and friction bearings in a wide temperature range and especially for the bearing-lubrication under high thermal and mechanical loads.
r.tecc Norplex VSP 2 / Rhenus Norplex VSP 2 offers a high mechanical stability, even at the presence of water. It provides thus for a good sealing of bearings at humid operating conditions. |
|
Application examples
|
Lubrication of bearings in the wet wire section and in the hot dryer section of paper- machines, adjustable mechanism in wind-powered devices, bearings of electric motors, pumps, forging presses, calenders, lubrication of thermally high loaded bearings in the steel industry.
Advantages:
pumpable in central lubricating systems
high thermal resistance
water resistant
high mechanical stability
good corrosion protection
high pressure load capacity
the grease meets the requirements of the specification VN 108 of Voith Paper for the use in wet and dry areas of paper machines |
|
Technical Data
|
| Thickener |
|
Lithium complex-Calcium |
| Operating temperature for long-term lubrication |
|
-25 to +150℃ |
| Short time admissible temperature peak value |
|
+200℃ |
| Permanent temperatures above 150℃ require regreasing at shorter intervals subject to thermal load |
| Drop point |
ASTM D 2265 |
> 250℃ |
| Worked penetration after 60 strokes |
ASTM D 217 |
265 to 295 1/10 mm |
| Penetration loss after 105 strokes |
ASTM D 217 |
< 30 1/10 mm |
| Penetration loss after 105 strokes with 20% water |
ASTM D 217 |
< 50 1/10 mm |
| Type of base oil |
|
Mineral oil |
| Base oil viscosity at 40℃ |
ASTM D 445 |
420 mm²/s |
| Water resistance |
DIN 51 807-01 |
1 – 90 |
| Emcor Test with 1% NaCl |
IP 220/85 |
Corrosion degree 0/0 |
| Copper Corrosion |
|
Corrosion degree 1-150 |
| FAG-FE9 - Test |
DIN 51821-02-A/1500/6000-150 |
F50 > 100 h
|
| FAG-FE8 - Test |
DIN 51819-02
7,5 / 80 - 120 |
m WK : 3 / 6 mg
|
| Designation |
DIN 51 502 |
KP 2 P-20 |
Subject to modification of the technical data. Please refer to the material safety data sheet for additional information or contact our application engineers. |
